Home / OUR QUALITY

DEDICATION TO QUALITY AND PERFORMANCE

Before leaving the factory, every single unit goes through extensive testing protocol to guarantee the highest level of quality. 

STEAMER

(overall 15-point assembly & inspection QC procedures)
Key functional tests conducted:
  • Each boiler undergoes a structural integrity test: high-pressure air is used to check for leaks
  • Every boiler and printed circuit board assembly (PCBA) are tested together to ensure proper functionality: connected to power supply and activated via programming signals.
  • Every water tank assembly undergoes a test for water-tightness: high pressure air is used to check for leaks
  • Each fully assembled handheld steamer is tested for proper wiring and insulation against shocks while handling
  • The steam output and adjustment levels are tested on every completed handheld unit (filled with water and run). The output gauges are re-calibrated at this stage if need be.
  • The functionality of the steamer is finally tested in the upright configuration using a mopstick and handheld unit together.

    VACUUM

    (overall 15-point assembly & inspection QC procedures)

    Key functional tests conducted:

    • Each turbine assembly is tested for proper balance and rotational stability at high RPMs
    • The airflow and suction levels are tested on every handheld vacuum unit for both normal mode and turbo mode
    • Each handheld vacuum is run continuously for 10-15 minutes to confirm overall functionality: motor, battery, circuitry.

    MOPSTICK

    (overall 10-point assembly & inspection QC procedures)

    Key functional tests conducted:

    • Electrical connections and proper signal transfer are tested on each Mopstick to ensure beater bar functionality
    • Vacuum intake path is tested for air-tightness on each mopstick. Custom seals and high pressure vacuum system are used to check for air leaks.